Nokia 7302 - Table 408 Shutdown Command; Generic Commands; 7 Virtual Private Routed Network Service

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 447
7.10.1 Generic Commands
7.10.1.1 shutdown
Table 408 shutdown command
Item Description
Syntax [no] shutdown
Context configure>service>vprn
configure>service>vprn
configure>service>vprn>interface
configure>service>vprn>interface>dhcp
configure>service>vprn>interface>ipv6>dhcp6-relay
configure>service>vprn>interface>sap
configure>service>vprn>bgp
configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
configure>service>vprn>ospf
configure>service>vprn>ospf>area>interface
configure>service>vprn>rip
configure>service>vprn>rip>group
configure>service>vprn>rip>group>neighbor
configure>service>vprn>router-advertisement>interface
Description This command administratively disables an entity. When disabled, an entity does not change,
reset, or remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities
contained within. Many objects must be shut down before they may be deleted.
Services are created in the administratively down (shutdown) state. When a no shutdown
command is entered, the service becomes administratively up and then tries to enter the
operationally up state. Default administrative states for services and service entities is
described below in Special Cases.
The no form of this command places the entity into an administratively enabled state.
If the AS number was previously changed, the BGP AS number inherits the new value.
Special Cases Service Admin State — A service is regarded as operational providing that one IP Interface
SAP is operational.
VPRN BGP and RIP — This command disables the BGP or RIP instance on the given IP
interface. Routes learned from a neighbor that is shutdown are immediately removed from the
BGP or RIP database and RTM. If BGP or RIP is globally shutdown, then all RIP group and
neighbor interfaces are shutdown operationally. If a BGP or RIP group is shutdown, all
member neighbor interfaces are shutdown operationally. If a BGP or RIP neighbor is
shutdown, just that neighbor interface is operationally shutdown.