FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 541
7.10.10.35 timers
Table 574 timers command
7.10.10.36 lsa-arrival
Table 575 lsa-arrival command
Parameters reference-bandwidth — The reference bandwidth in kilobits per second expressed as a
decimal integer.
Values: 1 — 1000000000
Item Description
(2 of 2)
Item Description
Syntax timers
Context configure>service>vprn>ospf
Description This command enables the context that allows for the configuration of OSPF timers. Timers
control the delay between receipt of a link state advertisement (LSA) requiring a Dijkstra
(Shortest Path First (SPF)) calculation and the minimum time between successive SPF
calculations.
Changing the timers affect CPU utilization and network reconvergence times. Lower values
reduce convergence time but increase CPU utilization. Higher values reduce CPU utilization
but increase reconvergence time.
Default None
Item Description
Syntax lsa-arrival lsa-arrival-time
no lsa-arrival
Context configure>service>vprn>ospf>timers
Description This parameter defines the minimum delay that must pass between receipt of the same Link
State Advertisements (LSAs) arriving from neighbors. It is recommended that the neighbors
configured (lsa-generate) lsa-second-wait interval is equal or greater then the lsa-arrival-time
configured here.
Use the no form of this command to return to the default.
Default no lsa-arrival
Parameters lsa-arrival-time — Specifies the timer in milliseconds. Values entered that do not match this
requirement will be rejected.
Values: 0 — 600000
To Next Page
Loading...
