Nokia 7302 - Local-Proxy-Nd; Table 481 Local-Proxy-Nd Command; Table 482 Sap Command

Virtual Private Routed Network Service
490
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.6.17 local-proxy-nd
Table 481 local-proxy-nd command
7.10.7 SAP Commands
7.10.7.1 sap
Table 482 sap command
Parameters number — The maximum number of ICMP unreachable messages to send. This parameter
must be specified with the seconds parameter.
Values: 10 — 1000
seconds — The time frame in seconds used to limit the number of ICMP unreachable
messages that can be issued.
Values: 1 — 60
Item Description
(2 of 2)
Item Description
Syntax [no]local-proxy-nd
Context configure>service>vprn>interface>ipv6
Description This command enables or disables neighbor discovery on the interface.
When enabled, the ISAM will behave as follows:
• Respond to all neighbor solicitation messages received on the IP interface for IPv6
addresses in the subnet(s) with the system MAC address as link layer address, provided
the link layer address of the destination/target IP address was learned and thus available
in the ISAM’s neighbor cache.
• Forward IPv6 traffic between hosts in the subnet(s) of the IP interface.
• Drop IPv6 traffic between hosts if the link layer address information for the IPv6 destination
has not been learned.
Item Description
Syntax sap sap-id create
no sap sap-id
Context configure>service>vprn>interface
(1 of 2)