Nokia 7302 - CCM-Ltm-Priority; Table 215 CCM-Ltm-Priority Command; Table 216 Low-Priority-Defect Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 301
5.16.4.8 ccm-ltm-priority
Table 215 ccm-ltm-priority command
5.16.4.9 low-priority-defect
Table 216 low-priority-defect command
Item Description
Syntax ccm-ltm-priority priority
no ccm-ltm-priority
Context configure>service>vpls>sap>eth-cfm>mep
configure>service>vpls>mesh-sdp>eth-cfm>mep
configure>service>vpls>spoke-sdp>eth-cfm>mep
configure>eth-ring>path>eth-cfm>mep
Description This command enables configuration of priority for CCM and LTM messages
Default 7
Parameters priority - Priority of the CCM/LTM Message
Value: 0...7
Item Description
Syntax low-priority-defect { allDef | macRemErrXcon | remErrXcon | errXcon | xcon | noXcon}
Context configure>service>vpls>sap>eth-cfm>mep
configure>service>vpls>mesh-sdp>eth-cfm>mep
configure>service>vpls>spoke-sdp>eth-cfm>mep
configure>eth-ring>path>eth-cfm>mep
Description This command specifies the lowest priority defect that is allowed to generate a fault alarm.
Default macRemErrXcon
Parameters allDef - DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM and DefXconCCM
macRemErrXcon - DefMACstatus, DefRemoteCCM, DefErrorCCM and DefXconCCM
remErrXcon - DefRemoteCCM, DefErrorCCM and DefXconCCM
errXcon - DefErrorCCM and DefXconCCM
xcon - DefXconCCM
noXcon - No defects DefXcon or lower are to be reported