Internet Enhanced Service
366
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
6.10 IES Service CLI Configuration Commands
The following commands are described:
• Generic Commands
• IES Global Commands
• IES QoS Policy Commands
• IES Interface Commands
• IES Interface DHCP Commands
• IES Interface ICMP Commands
• IPv6 Commands
• IES SAP Filter and QoS Policy Commands
• Show Commands
• Clear Commands
6.10.1 Generic Commands
6.10.1.1 shutdown
Table 319 shutdown command
Item Description
Syntax [no] shutdown
Context configure>service>ies
configure>service>ies>interface
configure>service>ies>interface>dhcp
configure>service>vprn>interface>ipv6>dhcp6-relay
configure>service>ies>interface>sap
Description This command administratively disables an entity. When disabled, an entity does not change,
reset, or remove any configuration settings or statistics. The operational state of the entity is
disabled as well as the operational state of any entities contained within. Many objects must
be shut down before they may be deleted.
Services are created in the administratively down (shutdown) state. When a no shutdown
command is entered, the service becomes administratively up and then tries to enter the
operationally up state. Default administrative states for services and service entities is
described below in Special Cases.
The no form of this command places the entity into an administratively enabled state.
(1 of 2)
To Next Page
Loading...
