FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 509
7.10.9.21 ibgp-multipath
Table 518 ibgp-multipath command
7.10.9.22 import
Table 519 import command
Default 90 seconds
Parameters seconds — The hold-time, in seconds, expressed as a decimal integer. A value of 0 indicates
the connection to the peer is up permanently.
Values: 0, 3 — 65535
Item Description
(2 of 2)
Item Description
Syntax [no] ibgp-multipath
Context configure>service>vprn>bgp
Description This command defines the type of IBGP multipath to use when adding BGP routes to the route
table if the route resolving the BGP nexthop offers multiple nexthops.
The no form of the command resets the IBGP multipath feature to the default value
(load-balance).
Default ibgp-multipath load-balance
Item Description
Syntax import policy [policy...]
no import
Context configure>service>vprn>bgp
configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
Description This command specifies the import policies to be used to control routes advertised to BGP
neighbors. Route policies are configured in the configure>router>policy-options context.
When multiple policy names are specified, the policies are evaluated in the order they are
specified. A maximum of five (5) policy names can be specified. The first policy that matches
is applied.
The no form of this command removes all route policy names from the import list.
Default no import — BGP accepts all routes from configured BGP neighbors. Import policies can be
used to limit or modify the routes accepted and their corresponding parameters and metrics.
Parameters policy — A route policy statement name.
To Next Page
Loading...
