Nokia 7302 - Other-Stateful-Configuration; Table 423 Mtu Command; Table 424 Other-Stateful-Configuration Command; Table 425 Prefix Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 457
7.10.2.13 mtu
Table 423 mtu command
7.10.2.14 other-stateful-configuration
Table 424 other-stateful-configuration command
7.10.2.15 prefix
Table 425 prefix command
Item Description
Syntax mtu mtu-bytes
no mtu
Context configure>service>vprn>router-advertisement>interface
Description This command configures the MTU for the nodes to use to send packets on the link.
Default no mtu — The MTU option is not sent in the router advertisement messages.
Parameter mtu-bytes — Specify the MTU for the nodes to use to send packets on the link.
Values: 1500 — 2026
Item Description
Syntax [no] other-stateful-configuration
Context configure>service>vprn>router-advertisement>interface
Description This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is
available for autoconfiguration of other (non-address) information such as DNS-related
information or information on other servers in the network. See RFC 3736, Stateless Dynamic
Host Configuration Protocol (DHCP) for IPv6.
Default no other-stateful-configuration
Item Description
Syntax [no] prefix [ipv6-prefix/prefix-length]
Context configure>service>vprn>router-advertisement>interface
Description This command configures an IPv6 prefix in the router advertisement messages. To support
multiple IPv6 prefixes, use multiple prefix statements. No prefix is advertised until explicitly
configured using prefix statements.
Default None
(1 of 2)