Virtual Private Routed Network Service
450
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.2.2 aggregate
Table 412 aggregate command
Parameters service-id — The unique service identification number identifying the service in the service
domain. This ID must be unique to this service and may not be used for any other service of
any type. The service-id must be the same number used for every ISAM on which this service
is defined.
Values: 1 — 2147483648
customer customer-id — Specifies the customer ID number to be associated with the service.
This parameter is required on service creation and optional for service editing or deleting.
Values: 1 — 2147483647
Item Description
(2 of 2)
Item Description
Syntax aggregate ip-prefix/ip-prefix-length [summary-only] [as-set] [aggregator
as-number:ip-address]
no aggregate ip-prefix/ip-prefix-length
Context configure>service>vprn
Description The operator may create an aggregate route. Then depending on the policies configured for
the routing protocols (RIP, BGP, IS-IS, OSPF), and the configuration of the aggregate route,
the system will advertise this route in addition to the learned sub-routes, or instead of the
learned sub-routes.
For example, if aggregate route 10.0.0.0/16 is created as “summary-only”, and route
10.0.128.0/17 is learned, than 10.0.0.0/16 will be advertised instead of 10.0.128.0/17.
The no form of the command removes the aggregate route.
To remove the “summary-only”, enter the command without the summary-only keyword, that
is,
configure service vprn service-id aggregate ip-prefix/ip-prefix-length
(1 of 2)
To Next Page
Loading...
