Nokia 7302 - Table 284 Static Command Output Fields; Table 285 Statistics Command; Statistics

Virtual Private LAN Service
338
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
Table 284 describes the command output fields.
Table 284 Static Command Output Fields
5.16.8.7 statistics
Table 285 statistics command
Parameters sap sap-id — Specifies the physical port identifier portion of the SAP definition.
Values: {port-id | lag-id}:{vlanid | no-tag}
• port-id
Specifies the physical port ID in the following format:
<port-id>: <nwport-id | ltport-id>
nwport-id - <slot-address>:<port-type>:<port-num>
— slot-address - nt|nt-a|nt-b|ntio-1
— port-type - sfp | xfp |vp | eth | ieee1588 | AI
— port-num - port-number
ltport-id - lt:<rack>/<shelf>/<slot>
— lt - keyword
— rack - number identifying the rack
— shelf - number identifying the shelf
— slot - number identifying the slot
• lag-id
lag: keyword
id: 1 — 64
• vlanid
Specifies the VLAN ID to be associated with the port identified by the SAP. For v-VPLS,
the SAP VLAN ID must match the VLAN ID defined at the v-VPLS level. The null value can
also be specified, to indicate that the SAP will send and receive untagged frames. If this
SAP is not defined, untagged frames will be dropped.
The m-VPLS VLAN ID is always specified as no-tag, which is reserved for untagged L2CP
frames processed to be by the m-VPLS.
Values:
m-VPLS vlanid: no-tag
v-VPLS vlanid: 0 | 1— 4093 (0 specifies untagged frames)
Label Description
Source Displays the IP source address used in IGMP queries.
Group Displays the static IGMP snooping source groups for a specified SAP.
Item Description
(2 of 2)
Item Description
Syntax statistics [sap sap-id]
(1 of 2)