FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 577
Table 632 Show Group Output
Label Description
Group BGP group name
Group Type No Type — Peer type not configured.
External — Peer type configured as external BGP peers.
Internal — Peer type configured as internal BGP peers.
State Disabled — The BGP peer group has been operationally disabled.
Down — The BGP peer group is operationally inactive.
Up — The BGP peer group is operationally active.
Peer AS The configured or inherited peer AS for the specified peer group.
Local AS The configured or inherited local AS for the specified peer group.
Local Address The configured or inherited local address for originating peering for the specified peer
group.
Loop Detect The configured or inherited loop detect setting for the specified peer group.
Connect Retry The configured or inherited connect retry timer value.
Authentication None — No authentication is configured.
MD5 — MD5 authentication is configured.
Local Pref The configured or inherited local preference value.
MED Out The configured or inherited MED value assigned to advertised routes without a MED
attribute.
Min Route Advt. The minimum amount of time that must pass between route updates for the same IP
prefix.
Min AS Originate The minimum amount of time that must pass between updates for a route originated
by the local router.
Multihop The maximum number of router hops a BGP connection can traverse.
Multipath The configured or inherited multipath value, determining the maximum number of
ECMP routes BGP can advertise to the RTM.
Prefix Limit No Limit — No route limit assigned to the BGP peer group.
1 - 4294967295 — The maximum number of routes BGP can learn from a peer.
Passive Disabled — BGP attempts to establish BGP connections with neighbors in the
specified peer group.
Enabled — BGP will not actively attempt to establish BGP connections with
neighbors in the specified peer group.
Next Hop Self Disabled — BGP is not configured to send only its own IP address as the BGP
nexthop in route updates to neighbors in the peer group.
Enabled — BGP sends only its own IP address as the BGP nexthop in route updates
to neighbors in the specified peer group.
Aggregator ID 0 Disabled — BGP is not configured to set the aggregator ID to 0.0.0.0 in all originated
route aggregates sent to the neighbor in the peer group.
Enabled — BGP is configured to set the aggregator ID to 0.0.0.0 in all originated
route aggregates sent to the neighbor in the peer group.
(1 of 2)