Nord Drivesystems SK 300P Series - Display of M1 and M2 When Using Ethernetip

NORDAC ON / ON+ (SK 3xxP) – Manual with installation instructions
44 BU 0800 en-4521
LED Labelling Display Meaning
M2 – 1
ERR
NS
ERROR = Ethernet Error
Off
EtherCAT functioning normally on the bus interface
Flashing (4 Hz)
General EtherCAT configuration error
Single flash
Bus interface has changed the EtherCAT state without authorisation
Double flash
EtherCAT or FI time-out (P513, P151)
M2 – 2
L/A
(Link activity)
Off
No connection
Yellow flashing
Connection is established, data is being transmitted
Green On
Connection is established, no data transmission
3.1.2 Display of M1 and M2 when using EthernetIP
LED Labelling Display Meaning
M1 – 1
L/A
(Link activity)
Off
No connection
Yellow flashing
Connection is established, data is being transmitted
Green On
Connection is established, no data transmission
M1 – 2
RUN
MS
MS = Module State
Off No mains or control voltage
Green On Bus interface working correctly
Green
flashing (4 Hz)
Bus interface not configured
Red
flashing (4 Hz)
Minor errors, faulty configuration
Red On Unrecoverable error
Red and Green
flashing
alternately (4 H
z)
Power-up, self test
M2 – 1
ERR
NS
NS = Network State
Off
No operating voltage, no IP address
Green On
CIP connection available
Green
flashing (4 Hz)
IP address configured but no CIP connection available
Green
flashing (0.5 Hz
)
Frequency inverter is ready to switch-on, but not enabled
Red
flashing (4 Hz)
Time-out, an "exclusive owner connection” has a time-out error
Red On
Dual IP. The IP address used by the bus interface is already in use
Red and Green
flashing
alternately (4 H
z)
Power-up, self test
M2 – 2
L/A
(Link activity)
Off
No connection
Yellow flashing
Connection is established, data is being transmitted
Green On
Connection is established, no data transmission