Maintenance
5-7
Part 1107600_03
2014 Nordson Corporation
To replace the adhesive filter
1. Relieve the system pressure. Refer to Relieving System Pressure at the
beginning of this section.
2. Remove the side base panel.
3. Use an 8 mm (
5
/
16
‐inch) hex‐head wrench or an adjustable wrench to
loosen (counterclockwise) and then remove the adhesive filter.
4. Properly dispose of the old filter.
5. Confirm that the O‐ring on the new adhesive filter is in good condition
(100‐mesh filter is P/N 1028305).
NOTE: 50‐ and 150‐mesh filters are also available (P/Ns 1021941 and
1034720).
6. Screw the filter into the pump body and then tighten the filter to
4.5 Nm (40 in.‐lb).
7. Reinstall the side base panel and resume normal operation.
Figure 5‐3 Replacing the adhesive filter
To Next Page
Loading...
