Setup key
Installation
3-20
Part 1107600_03
2014 Nordson Corporation
Selecting Operating Parameters
Table 3‐5 provides a complete list of the operating parameters. Review the
list to determine which operating parameters would best support your
manufacturing process. Refer to Appendix B, Operating Parameters, for
detailed information about each parameter. Appendix B contains a complete
description of each parameter, including its affect on the melter, default
value, and format.
NOTE: Parameters that are used to configure optional equipment or that are
otherwise reserved in the firmware are excluded from Table 3‐5.
NOTE: Motor control parameters are set differently from operating
parameters. Refer to Setting Up the Motor Control later in this section. Some
applications will require a change to one or more motor control parameters.
Reading or Editing Operating Parameters
Regardless of whether a parameter's value is editable or not, the procedure
for accessing each parameter in order to read or edit its current value is the
same.
To read or edit a parameter
1. Switch the melter on.
The melter performs a start‐up check.
2. Press the Setup key.
The left display flashes parameter 1.
To Next Page
Loading...
