Installation
3-10
Part 1107600_03
î 2014 Nordson Corporation
Mounting the Melter
Before mounting the melter, ensure that the parent machine or support
structure is level with respect to the floor, provides an even mounting surface,
is not subject to extreme vibration, and is capable of supporting the weight of
the melter, a full tank of hot melt, and the hoses and guns.
Refer to Section 8, Technical Data, for the weight of the melter. Refer to the
technical data provided by the hot melt manufacturer for information about
the volumetric weight of the hot melt.
To mount the melter
See Figure 3â4. Use 8 mm (
5
/
16
in.) machine bolts and locking hardware to
secure the melter base assembly to the mounting surface.
F
B
D
A
381 mm
(15.00 in.)
318 mm
(12.50 in.)
249 mm
(9.80 in.)
257 mm
(10.12 in.)
14 mm
(0.56 in.)
10 mm
(0.38 in.)
Figure 3-4 Bolt mounting pattern
To Next Page
Loading...
