Operation
4-23
Part 1107600_03
2014 Nordson Corporation
Adjusting Component Temperatures
You can adjust the setpoint temperature of heated components using the
following methods:
Global—The tank and all hoses and guns are set to the same
setpoint temperature.
Global‐by‐component group—All of the hoses or all of the guns are
set to the same setpoint temperature.
Individual Component—The setpoint temperature of the tank
and each hose and gun is adjusted independently.
Before adjusting setpoint temperatures, confirm that each hose/gun pair
is connected to the correct hose/gun receptacle. For example, hose/gun pair
1 should be connected to the receptacle 1. Refer to More About Heated
Components earlier in this section for information about hose/gun positions.
To Next Page
Loading...
