Tank key
Left display and scroll key
Enter key
Ready LED
Operation
4-24
Part 1107600_03
2014 Nordson Corporation
Adjusting Component Temperatures (contd)
To adjust setpoint temperatures using the global method
1. Press and hold the Tank key for three seconds.
The left display flashes 1.
2. Scroll the left display to 0 (flashing).
The right display indicates all dashes (‐‐‐‐) and the LEDs on all of
the component keys turn green.
3. Press the Enter key.
The right display flashes.
4. Use the keypad to enter the setpoint temperature recommended by
the manufacturer of the hot melt. Refer to the technical data
sheet provided by the manufacturer of the hot melt to determine the
optimal setpoint temperature.
NOTE: If the keypad or the right‐display scroll keys have no affect on the
right display, the melter is password protected. You must enter a valid
password before you can change setpoint temperatures. Refer Enter the
Melter Password, later in this section.
5. Press the Tank key.
All components begin to heat or cool to the new global
setpoint temperature. When all of the components reach their
setpoint temperature, the ready LED turns on (green).
To Next Page
Loading...
