Nordson AltaBlueA4TP - Connecting the PC and the Melter

Melter Communications
C-5
Part 1107600_03
 2014 Nordson Corporation
Connecting the PC and the Melter
To connect the PC to the melter, order communication cable part 1029938
(sold separately). Refer to Communication Cable in Section 7, Parts, for the
cable description.
1. Open the electrical enclosure door.
2. Connect communication cable part 1029938 to connector J3 on the
CPU/display board.
3. Connect a serial cable from the PC COM port (selected during the
software installation routine) and the serial connector on the
communication cable.
J1
TP2 (+)
TP4 (−)
CPU Power
(green)
CPU Failure
(red)
4.75−5.25 VDC
CPU Board (B22)
J3
Figure C‐1 Location of J3 on the CPU/display board (I/O expansion card not shown for clarity)