Melter Communications
C-1
Part 1107600_03
2014 Nordson Corporation
Appendix C
Melter Communications
This appendix describes the installation and use of the Nordson
Configuration Manager (NCM) communications utility. With this utility you
can:
transfer operating parameters and temperature setpoints between
melters
upgrade or reload your melter's firmware
Software Availability
If you do not already have the NCM utility, you can download it from the
internet by navigating to www.enordson.com/support.
If you do not have a connection to the internet, you can request a software
CD from your Nordson representative.
System Requirements
The following hardware and software requirements are necessary to install
and run Blue Series software:
Any AltaBlue, ProBlue, or DuraBlue adhesive melter
Serial cable
Communication cable (part number 1029938)
Personal computer with:
‐ CD‐RW drive or 3.5‐inch floppy drive
‐ Available COM port
‐ 640 x 480 color monitor
‐ Windows 95, 98 (second edition), ME, XP, or 2000
‐ Internet Explorer version 4.0 or later (IE 5.0 is recommended)
‐ Administrative privileges (Windows XP, 2000, and NT)
To Next Page
Loading...
