Troubleshooting
6-18
Part 1107600_03
2014 Nordson Corporation
Table 6-13 Pump Operating Variables (Columns 1−5)
R
o
w
1 2 3 4 5
Master Pump
LED Status
Master Pump Key
Press Status
(See Note A)
Individual Pump
LED Status
Individual Pump
Key Press Status
(See Note A)
Remote Motor
Input Assigned
(See Note B)
1 Off Not pressed Off Off/Ignored Not Assigned
2 Single green flash, then off Ignored Off Off/Ignored Not Assigned
3 Green On Off Off Not Assigned
4 Green On Green On Not Assigned
5 Off Not pressed Off Off/Ignored Not Assigned
6 Yellow On Off Off/Ignored Not Assigned
7 Green On Off Off Not Assigned
8 Green On Green On Not Assigned
9 Off Not pressed Off Off/Ignored Not Assigned
10 Single green flash, then off Ignored Off Off/Ignored Not Assigned
11 Yellow On Off Off/Ignored Not Assigned
12 Green On Off Off Not Assigned
13 Green On Green On Not Assigned
14 Off Not pressed Off Off/Ignored Not Assigned
15 Yellow On Off Off/Ignored Not Assigned
16 Yellow On Off Off/Ignored Not Assigned
17 Green On Off Off Not Assigned
18 Green On Green On Not Assigned
19 Off Not pressed Off Off/Ignored Assigned
20 Single green flash, then off Ignored Off Off/Ignored Assigned
21 Flashing green On Off Off/Ignored Assigned
22 Green On Off Off Assigned
23 Green On Green On Assigned
24 Off Not pressed Off Off/Ignored Assigned
25 Yellow On Off Off/Ignored Assigned
26 Flashing green On Off Off/Ignored Assigned
27 Green On Off Off Assigned
28 Green On Green On Assigned
29 Off Not pressed Off Off/Ignored Assigned
30 Single green flash, then off Ignored Off Off/Ignored Assigned
31 Flashing green On Off Off/Ignored Assigned
32 Green On Off Off Assigned
33 Green On Green On Assigned
34 Off Not pressed Off Off/Ignored Assigned
35 Yellow On Off Off/Ignored Assigned
36 Flashing green On Off Off/Ignored Assigned
37 Green On Off Off Assigned
38 Green On Green On Assigned
NOTE A: “On” means that the pump key was pressed and the unit accepted the key press. “Ignored” means that the
pump key will not respond to a key press. “Off” means that the key was not pressed.
B: If any of Parameters 30-39 are set to 3 or 11, then the remote motor input is assigned.
To Next Page
Loading...
