Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 2-50 P/N 196515 (Revision A)
Exercise Sheet 2-6-1
Focusing the Camera
Tools and Materials Needed:
5-mm hex key
4-mm hex key
Sample workpiece
The camera can be focused using both a coarse adjustment and a fine adjustment
depending on the extent of focusing necessary. Usually, only the fine adjustment is
required.
Coarse Focus Adjustment:
1. To make a coarse focus adjustment, perform the following:
Use a 5-mm hex key to loosen the two socket-head cap screws on the back
of the vertical camera bracket.
- While loosening the cap screws, hold onto the camera with one hand to
ensure that it does not suddenly slide down to the bottom of the slot in
the camera bracket and become damaged.
While looking at the image in the video window, slide the camera either up
or down in the bracket until the image becomes clear and focused.
When you are satisfied with the coarse focus of the video image, use the 5-
mm hex key to tighten the upper screw on the vertical camera bracket.
2. If necessary, perform the fine focus adjustment.
Fine Focus Adjustment:
1. To make a fine focus adjustment, use a 4-mm hex key to turn the adjustment
screw on the top of the camera adjustment bar until you are satisfied with the
focus of the video image.
2. Tighten the lower screw on the vertical camera bracket.
3. Recalibrate the camera as described in
Exercise Sheet 2-6-2.
4. Perform a Valve Offsets Routine.
To Next Page
Loading...
Need help?
General