Nordson Asymtek X-1010 User Manual

Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 4-67 P/N 196515 (Revision A)
Lesson 4-6
Troubleshooting the Servo Controller (PMAC)
A. Introduction
The PMAC (Programmable Multi-Axis Controller) controls the positioning of the
dispense head. This section outlines symptoms, probable causes and fault
isolation procedures for PMAC problems. FmNT error messages displayed on the
computer monitor are also discussed.
B. Enabling Objectives
4.6 Identify possible causes of and solutions to Servo Controller (PMAC)
problems.
C. Topic Outline
1. Introduction
2. Overview
 PMAC Fault Isolation Procedure
 PMAC Troubleshooting Summary
 Troubleshooting Guidelines
3. Summary and Review

Nordson Asymtek X-1010 Specifications

General

Type	Dispenser
Accuracy	±25 µm
Fluid Types	Adhesives, sealants
Z-axis Clearance	Customizable based on configuration
Resolution	1 μm
Dispensing Technology	Positive Displacement
Maximum Dot Size	Varies with application
XY Positioning Accuracy	±25 µm
Z Axis Resolution	1 μm
Machine Dimensions	Varies based on configuration
Weight	Varies based on configuration
Power Requirements	200-240 VAC, 50/60 Hz