Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 4-105 P/N 196515 (Revision A)
• Look for damaged electrical cables
• Look for disconnected or poorly secured electrical cables.
• Look for obstructions to movement.
• Look for binding, loose, or damaged hardware.
• Look for worn, cracked, fraying O-ring belts or belt.
Perform the following inspections:
Resolve and go to Rear/
Front Belt Motor
Verification
Go to Rear/Front Belt
Motor Verification
Is mechanical
correction required as
a result of the above
inspections?
Yes No
• Look for damaged electrical cables
• Look for disconnected or poorly secured electrical cables.
• Look for obstructions to movement.
• Look for binding, loose, or damaged hardware.
• Look for worn, cracked, fraying O-ring belts or belt.
Perform the following inspections:
• Look for damaged electrical cables
• Look for disconnected or poorly secured electrical cables.
• Look for obstructions to movement.
• Look for binding, loose, or damaged hardware.
• Look for worn, cracked, fraying O-ring belts or belt.
Perform the following inspections:
Resolve and go to Rear/
Front Belt Motor
Verification
Go to Rear/Front Belt
Motor Verification
Is mechanical
correction required as
a result of the above
inspections?
Is mechanical
correction required as
a result of the above
inspections?
Yes No
Diagram Sheet 4-8-6
Conveyor Motors Fault Isolation Procedure – Mechanical Verification
To Next Page
Loading...
