Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 4-113 P/N 196515 (Revision A)
Is mechanical
correction required as
a result of the above
inspections?
Resolve and go to
Upstream Workpiece
Transfer Verification
Go to Upstream
Workpiece Transfer
Verification
Yes No
• Look for damaged electrical cables
• Look for disconnected or poorly secured electrical cables.
Perform the following inspections:
Is mechanical
correction required as
a result of the above
inspections?
Is mechanical
correction required as
a result of the above
inspections?
Resolve and go to
Upstream Workpiece
Transfer Verification
Go to Upstream
Workpiece Transfer
Verification
Yes No
• Look for damaged electrical cables
• Look for disconnected or poorly secured electrical cables.
Perform the following inspections:
• Look for damaged electrical cables
• Look for disconnected or poorly secured electrical cables.
Perform the following inspections:
Diagram Sheet 4-8-14
SMEMA Fault Isolation Procedure – Mechanical Verification
To Next Page
Loading...
