Maintenance
5-7
Part 1089210A04
E 2010 Nordson Corporation
Figure 5-5 Retaining Bar Removal
5. Carefully slide the two reflectors from the lamphead base.
NOTE: Great care should be taken when replacing reflectors as they are
made of glass and may break if dropped or forced.
Figure 5-6 Reflector Removal
6. Slide the new reflectors into the lamphead base.
NOTE: The inside edge of the reflector should slide into the notches of the
white retainers.
7. Set the retaining brackets in place. The placement of the retaining
brackets differs between focus and flood reflectors.
Focus Reflectors: See Figure 5-7. The edge of the reflector will sit on
the retainer springs on the inside edge of the bracket.
The lip on the focus bracket will go to the inside of the lamphead and
wrap around the reflector. Line up the retaining bracket mounting holes
with the mounting holes in the lamphead base.
To Next Page
Loading...