Nordson DuraBlue II - Electrical Data; Mechanical Data

Technical Data
8-2
Part 1126931_01
 2018 Nordson Corporation
Electrical Data
WARNING! The unit is designed for only one operating voltage. Operate
only at the operating voltage shown on the ID plate.
Available operating
voltages
400 V
AC
3‐phase with neutral (star — WYE)
Maximum melter power
requirements
20L 14740 W
45L 16540 W
Operating voltage
frequency
50/60 Hz
Fuse protection Refer to ID plate
Melter Internal Heater
Power Wattage
20L 45L
Grid: 3x900 W Grid: 5x900 W
Manifold: 3x800 W Manifold: 3x800 W
Max. load per hose
receptacle
1000 W, any single hose or applicator
1200 W, any hose/applicator pair
2000 W, sum of hose/applicator pairs 1 and 2
2000 W, sum of hose/applicator pairs 3 and 4
2000 W, any single hose, or applicator 5 or 6
2000 W, hose/applicator pair 5 or 6
4000 W, sum of hose/applicator pairs 5 and 6
NOTE: Total external wattage must not exceed 8,000 W.
Mechanical Data
Item 20L 45L
Weight 205 kg (451 lb) 240 kg (529 lb)
Tank opening (length and
width)
170 x 250 mm 170 x 250 mm
Melter Appearance (length,
width and height)
1250 x 600 x 1230 mm 1250 x 600 x 1230 mm
Approximate tank volume 20 L 45 L
Number of hose connections Single‐stream manifolds: 2 connections per pump stream