Table of Contents i
Part 1126931_01
2018 Nordson Corporation
Table of Contents
Safety 1-1.....................................................
Safety Alert Symbols 1‐1........................................
Responsibilities of the Equipment Owner 1‐2.......................
Safety Information 1‐2........................................
Instructions, Requirements, and Standards 1‐2..................
User Qualifications 1‐3.......................................
Applicable Industry Safety Practices 1‐3..........................
Intended Use of the Equipment 1‐3.............................
Instructions and Safety Messages 1‐4..........................
Installation Practices 1‐4......................................
Operating Practices 1‐4......................................
Maintenance and Repair Practices 1‐5.........................
Equipment Safety Information 1‐5................................
Equipment Shutdown 1‐6.....................................
Relieving System Hydraulic Pressure 1‐6.....................
De‐energizing the System 1‐6...............................
Disabling the Applicators 1‐6................................
General Safety Warnings and Cautions 1‐7......................
Other Safety Precautions 1‐10..................................
First Aid 1‐10.................................................
Safety Labels and Tags 1‐11.....................................
Introduction 2-1...............................................
Intended Use 2‐1..............................................
Electromagnetic Compatibility (EMC) 2‐1.......................
Examples of Unintended Use 2‐2..............................
Residual Risks 2‐2.............................................
Key Components 2‐3...........................................
Electrical Components 2‐4....................................
Control Panel 2‐5............................................
Tank Isolation Valve 2‐6......................................
Pressure Control Valves 2‐6..................................
Modes of Operation 2‐7.........................................
Automatic Scan (Normal Mode) 2‐7............................
Standby 2‐7................................................
Setup 2‐7..................................................
Fault 2‐7...................................................
Gear‐to‐Line Capability 2‐7......................................
Melter Identification 2‐8.........................................