Operation
4-1
Part 1126931_01
2018 Nordson Corporation
Section 4
Operation
WARNING! Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
This section provides information about the following operator‐level tasks:
Filling the melter tank
Starting the melter
(Optional) Adjusting the speed of the motor(s)
(Optional) Adjusting material pressure
Monitoring melter operation
Adjusting the operating temperature of heated components
Using the melter function keys
Shutting the melter down
Most of the controls described in this section are located on the
control panel. Refer to Key Components in Section 2, Introduction, for
the location of the controls and indicators described in this section.
Additional Information
This section presents operating procedures in their most commonly used
form. Procedural variations or special considerations are explained in the
additional information table that follows most procedures. Where applicable,
some table entries also contain cross‐reference information. Additional
information tables are indicated by the symbol shown to the left.
To Next Page
Loading...
