Melter Communications
C-1
Part 1126931_01
2018 Nordson Corporation
Appendix C
Melter Communications
This appendix describes the installation and use of the Nordson
Configuration Manager (NCM) communications utility. With this utility you
can:
transfer operating parameters and temperature set‐points between
melters
upgrade or reload your melter's firmware
Software Availability
If you do not already have the NCM utility, you can download it from
http://emanuals.nordson.com/adhesives/software/BlueSeriesSoftware.html.
System Requirements
The following hardware and software requirements are necessary to install
and run Blue Series software:
Any DuraBlue II, AltaBlue, ProBlue, or DuraBlue 10/16 adhesive
melter
Serial cable
Personal Computer with:
‐ CD-RW drive or 3.5-inch floppy drive
‐ Available COM port
‐ 640 x 480 color monitor
‐ Windows 95, 98 (second edition), ME, XP, or 2000
‐ Internet Explorer version 4.0 or later (IE 5.0 is recommended)
‐ Administrative privileges (Windows XP, 2000, and NT)
To Next Page
Loading...
