Installation
3-12
Part 1126931_01
2018 Nordson Corporation
Connect Applicators
Observe the following guidelines:
DuraBlue II melters with 120‐ohm nickel sensors support all Nordson
T‐style applicators. DuraBlue‐II melters with 100‐ohm platinum sensors
support all Nordson M‐style applicators.
For information about choosing the most appropriate Nordson hot melt
applicator for your manufacturing process, refer to the latest edition of
Nordson's hot melt dispensing equipment Replacement Parts Catalog or
contact your Nordson representative. Refer to Appendix A, Calculating
Melter Power Requirements, for information about how to calculate the
power required by Nordson hot melt applicators.
Refer to the user's guide that is shipped with each applicator for
information about installing the applicator and connecting a hose to the
applicator.
NOTE: DuraBlue II adhesive melters are shipped with a 0.2 mm hot melt
filter installed in the manifold. Order the appropriate applicator nozzle based
on this filter mesh size.
To Next Page
Loading...
