Operation
4-26
Part 1126931_01
2018 Nordson Corporation
Shutting Down the Melter
Shut the melter down when it will not be used for an extended period of time.
To shut the melter down
1. Press the pump enable key(s) to disable the motor(s).
2. Place the control switch in the OFF position.
3. Place the main power switch in the OFF position.
4. Disable the applicators as follows:
Air‐operated applicators: turn off the air supply to the applicators.
Electric applicators: turn off the applicator driver, pattern controller, or
timer.
To Next Page
Loading...
