Nordson DuraBlue II User Manual

Table of Contents
ii
Part 1126931_01
 2018 Nordson Corporation
Installation 3-1................................................
Overview 3‐1..................................................
Additional Information 3‐1.....................................
Installation Tasks 3‐2........................................
Experience of Installation Personnel 3‐2........................
Installation Requirements 3‐2....................................
Clearances 3‐2..............................................
Ventilation 3‐4..............................................
Electrical Power 3‐4..........................................
Other Considerations 3‐5.....................................
Unpacking the Melter 3‐6.......................................
Moving the Unpacked Melter 3‐6..............................
Contents of the Installation Kit 3‐6..............................
Customer‐Supplied Materials 3‐6..............................
Configuring the Electrical Service 3‐7.............................
Residual Current Circuit Breakers 3‐7..........................
Connecting the Electrical Service 3‐7...........................
Connecting Hoses and Applicators 3‐9............................
Connect Hoses 3‐9..........................................
Connect Applicators 3‐12......................................
Setting Up the Melter 3‐13........................................
Quick Setup 3‐13.............................................
Operating Parameters 3‐15....................................
Selecting Operating Parameters 3‐15.........................
Reading or Editing Operating Parameters 3‐16.................
Set‐point Temperature of the Tank, Hoses, and Applicators 3‐20....
Save and Restore Melter Settings 3‐22..........................
Review Parameter and Set‐point Temperature Changes 3‐23.......
Setting Up Inputs/Outputs 3‐25...................................
Wire Inputs/Outputs to the Melter 3‐26...........................
Set Up Inputs/Outputs 3‐27....................................
Setting Up Gear‐to‐Line Operation 3‐31............................
Setting Up Motor Run Status Monitoring 3‐32.......................
Wiring 3‐32..................................................
Keypad Buttons 3‐32.........................................
Programming 3‐33............................................
Installing Optional Equipment 3‐34................................
Connecting an Applicator Driver, Pattern Controller, or Timer 3‐34.....
Flushing the Melter 3‐34.........................................
Disposing of Melter 3‐34.........................................
Operation 4-1.................................................
Additional Information 4‐1.......................................
Filling the Tank 4‐2.............................................
About Heated Components 4‐2..................................
Starting the Melter 4‐3..........................................
Manually Adjusting the Pump Speed 4‐6..........................
Adjust the Motor Speed for Manual Operation 4‐6................
Adjusting Material Pressure 4‐7..................................
Monitoring the Melter 4‐8.......................................
Confirm that the Melter is Operating Correctly 4‐8................
Monitor Component Temperatures 4‐9
.........................
Monitor Melter Faults 4‐11.....................................
Monitor the Service Interval 4‐17................................

Nordson DuraBlue II Specifications

General

Brand	Nordson
Model	DuraBlue II
Category	Power Tool
Language	English