Service
5-2
Part 1126931_01
2018 Nordson Corporation
Through the Melter Drain Valves
1. Disable the motor(s). Refer to Section 4, Operation.
2. Place a container under the drain valve ports located on the bottom of the
manifold.
3. Open all the drain valves. Adhesive will drain from the valves.
4. When adhesive stops draining, close the drain valves.
5. Re‐use the material or properly dispose it of according to local
regulations.
Figure 5‐1 Location of the melter drain valves
To Next Page
Loading...
