How to Use the Basic Program
3UR
UDP &KDQ
H
AFC-600 Programming PN 51032:A 3/8/99 25
+RZ WR 3UR
UDP 1$&V
DQG 3DQHO &LUFXLWV
Programming NAC (four NACs on the MPS-6) and Panel Circuits (connected through
J1 or J2) is like programming control modules—except for the Type Code and device
address.
)LJXUH 6DPSOH 1$& DQG 3DQHO 0RGXOH 3URJUDPPLQJ 6FUHHQ
To modify a point, follow these steps:
1RWH
$ EOLQNLQ
FXUVRU
LQGLFDWHV WKH VHOHFWHG ILHOG
1. From the programming screen, use the arrow keys to move to a field that you want
to modify and refer to Table 12 for descriptions and settings.
7DEOH +RZ WR 0RGLI
1$&3DQHO &LUFXLW 3UR
UDPPLQ
6HOHFWLRQV
2. When finished modifying a point, press the
ENTER
key; then press the
NEXT
or
PREVIOUS
key to select another point.
352*50 %(// &,5&8,7 3$1(/ &,5&8,7 12
===== ,6: %
:DON 7HVW 6HOHFWLRQ : VHOHFWHG
GHIDXOW RII
6ZLWFK ,QK LE LW , VHOHFWH G
RII GH IDX OW
%OLQNLQ
7
H &RGH VHOHFWLRQ
6LOHQFHDEOH
6 VHOH FWH G GH IDX OW
RII
7KH DGGUHVV RI DQ 1$& FRQQHFWHG
WKURX
K 1$& % 1$& %
1$&%RU1$&%RUWKH
DGGUHVV RI D 3DQHO &LUFXLW FRQQHFWHG
WKURX
K-RU-IRUH[DP
OH 3
UH
UHVHQWV 3DQHO &LUFXLW PRGXOH
FLUFXLW
)LYH ]RQHV IRU &%( OLVW WKH
GHIDXOW ]RQH VHOHFWLRQ LV
=
HQHUDO DODUP
Field Description Set as follows:
CBE zones Specifies up to five software zones
to define the output responses of the
NAC or Panel Circuit based on
various initiating conditions (events)
Enter address of up to five zones,
including F0-F9, R0-R9, and zones
00-99. The first zone default is Z00
(general alarm)
Type Code Specifies the function of the NAC or
Panel Circuit
Press the
NEXT
or
PREVIOUS
Selection keys to scroll through the
NAC or Panel Circuit Type Code
selections (listed in
Table 48 on page 100)
Switch Inhibit Specifies if an operator can
manually activate an output
I = Switch Inhibit enabled
* = Switch Inhibit disabled (default)
Silenceable Specifies if an operator can
manually silence an activated output
S = output silenceable (default)
* = output nonsilenceable
Walk Test Specifies if outputs sound during
Walk Test
W = devices sound (Standard Walk
test) - default
* = devices do not sound (Silent
Walk Test)
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
