Notifier AFC-600 - How to Change Sensitivity for a Detector

How to Change Sensitivity for a Detector
 6WDWXV &KDQ
J
H
AFC-600 Programming PN 51032:A 3/8/99 41
+RZWR&KDQJH6HQVLWLYLW\IRUD'HWHFWRU
The Detector Sensitivity option lets you change the Alarm and Pre-Alarm (sensitivity)
level for an installed detector. From the Status Change screen (Figure 48), press the
2
key to display the Detector Selection screen:
)LJXUH  'HWHFWRU 6HOHFWLRQ 6FUHHQ
+RZ WR 6HOHFW D 'HWHFWRU
Enter the SLC address of an installed detector in the LDAAA field as shown in Figure
51. The control panel displays the following screen:
)LJXUH  'HWHFWRU 6HQVLWLYLW\ 6FUHHQ
+RZ WR 8VH WKH 'HWHFWRU
6HQVLWLYLW
\
6FUHHQ
Use the instructions in Table 23 to change detector sensitivity, display additional
detectors, and set detector sensitivity values.
7DEOH  6HOHFWLQ
J
'HWHFWRU 6HQVLWLYLW
\
&
Status Change password
&
)

WR H[LW
'(7 6(16  &203 (17(5 32,176/'$$$(
%OLQNLQ
J
FXUVRU
352*50 602.( 3+272 '(7(&725 $''5 '
=2 = = = = $/ 3$  '
$ODUP /HYHO
3UH$ODUP /HYHO
1RWH
,I QRW XVLQ
J
3UH$ODUP
VHW 3$  3$  LV WKH
VHOIR
S
WLPL]LQ
J
PRGH )RU
GHWDLOV UHIHU WR $
SS
HQGL[ &
To Enter o r P ress
Display detector information
on the screen.
The detector address, then press
5
.
A value (1-9) or increase or decrease values by pressing
the
NEXT
or
PREVIOUS
keys:
/
or
0
Save the sensitivity values.
5
Display the next existing
detector address.
/
Display the previous existing
detector address.
0
Technical Manuals Online! - http://www.tech-man.com