Notifier AFC-600 - Page 51

How to Program a Releasing Zone
$
SS
HQGL[ $ 5HOHDVLQ
J
$
SS
OLFDWLRQV
AFC-600 Programming PN 51032:A 3/8/99 51
3UR
J
UDPPLQ
J
DQ $+-
$ERUW 6ZLWFK
The following contains information needed to program an AHJ Abort Switch:
Description
An AHJ (Authority Having Jurisdiction) delay timer that restores the
programmed Delay Timer.
Note
: An AHJ timer does not comply with UL Standard 864.
How to
program
1. Program the monitor module connected to the abort station with
the Type Code
ABORT SWITCH
as detailed in "How to Program a
Monitor Module" on page 23.
2. Select a time for the Releasing Zone Delay Timer (Table 27).
3. Program the Releasing Zone with the selection ABORT=AHJ
(sample shown in Figure 64).
How it
works
When an alarm initiates, the programmed Delay Timer starts. Press
and hold the Abort switch and the control panel suspends the Delay
Timer. When you release the Abort Switch, the control panel restores
the value of the programmed Delay Timer and the Delay Timer
counts down. When the Delay Timer expires, the control panel
activates Releasing Zone outputs.
Example
Figure 64 shows an example of a AHJ Abort Switch and a Delay
Timer programmed to Releasing Zone R05:
)LJXUH  $+- $ERUW 6ZLWFK ([DPSOH
5HOHDVH WKH $ERUW 6ZLWFK DQG FRQWURO
S
DQHO UHVWRUHV WKH
S
UR
J
UDPPHG YDOXH WKH
'HOD
\
7LPHU  VHF DQG FRXQWV GRZQ
'HOD
\
 VHF
3UHVV DQG KROG WKH
$ERUW 6ZLWFK
:KHQ WKH 'HOD
\
7LPHU
H[
S
LUHV WKH FRQWURO
S
DQHO DFWLYDWHV
5HOHDVLQ
J
=RQH RXW
S
XWV
35* 5(/($6( )81&7 5(/($6( &21752/
'(/$<  $%257 $+- &5266 1 62.  5
3UR
J
UDP VHOHFWLRQV IRU
5HOHDVLQ
J
=RQH 5
 VHF
 VHF
 VHF
7RWDO WLPH IURP DODUP LQLWLDWLRQ WR UHOHDVH
 VHFRQGV
$ODUP
 VHF
 VHF
 VHF
 VHF
 VHF
Technical Manuals Online! - http://www.tech-man.com