9RLFH $ODUP 6\VWHP
Installing an AMG
4-4 AFP-300/AFP-400 Installation PN 50253:C1 05/22/97
&RQILJXULQJ WKH $0*
An AMG appears as an annunciator to the control panel and operates on address 01.
Installing an AMG requires programming the control panel and setting the AMG-1 DIP
switch. Table 4-3 contains AMG programming and switch settings:
1RWH <RX FDQ VHW DQ $0* WR
UHFHLYH RQO\ ',3 EXW \RX
FDQQRW XVH WKH $//&$//
VZLWFK
Table 4-3 AMG Programming and Switch Settings
Figure 4-3 shows typical wiring for an AMG-1 configured for four-wire operation:
)LJXUH 7\SLFDO :LULQJ IRU DQ $0* )RXU:LUH &RQILJXUDWLRQ
Table 4-4 contains descriptions of the pins on the AMG-1 DIP switch:
Table 4-4 AMG-1 DIP Switch
For Set
Single-channel applications AMG-E RECEIVE ONLY switch to Off.
Dual-channel applications 1) AMG-1 Evacuation channel RECEIVE ONLY switch to Off; and
2) AMG-E Alert channel RECEIVE ONLY switch to On.
Optional four-wire return AMG-1 DIP switch to On.
Pin Function Setting
1 Four-wire audio supervision On
Off
2 Tone/Message Select Table 4-5 – Off
Table 4-6 – On
3 Receive Only Refer to Installing an AMG.
4 VRAM A Refer to Voice Message Options.
5 VRAM B Refer to Voice Message Options.
6 Message Select
Refer to Table 4-5 and Table 4-6.7 Message Select
8 Message Select
2
)
)
2
)) 21
$0* ',3 VZLWFK
3
3
3
3
%HOO
&NW
$XGLR,Q
VKOG VKO G
(9$& $OHUW
VKOG VKOG
3 3 3 3
7URXEOH ,Q ))7 (9$& $/(57
-
5
6:
5
www.PDF-Zoo.com
To Next Page
Loading...
Need help?
General
