Need help?Do you have a question about the Notifier UDACT and is the answer not in the manual?
General| Brand | Notifier |
|---|---|
| Model | UDACT |
| Category | Cell Phone |
| Language | English |
Standard mode of operation, monitoring FACP status and phone line voltage.
Used to program the UDACT. Host FACP status information is not received in this mode.
Defines device type or zone function, and can disable alarm reporting for specific zones/points.
Details UDACT installation, including options for different FACP cabinets or remote enclosures.
Overview of UDACT programming, storage, and essential user-programmed data.
Step-by-step instructions to access the UDACT's programming mode.
Instructions for programming the primary phone number, including valid entries and functions.
Instructions for programming the secondary phone number, similar to the primary.
Selects the communication format for the secondary phone number.
Identifies the installed control panel for correct UDACT operation.
Event code data programmed for primary number when Ademco Contact ID is selected at address 16.
Discusses operation of the UDACT in Normal Mode upon initial power up.
Transmission of 'UDACT Off Normal' fault message when changing modes, and restoral message.
Feature to disable reports for points defined as remote reset, acknowledge, silence, or drill switches.
Procedure for testing primary and secondary phone lines using the keypad.
Shows the data reporting structure for pulsed and Ademco Express formats, and Ademco Contact ID.
Structure of Ademco Contact ID reporting including subscriber ID, event code, and device/zone number.
Details the EIA-485 and 24VDC connections between UDACT and AFP-100.
Programming zones 1-99 by entries/addresses for identification.
Programming points for modules and detectors across loops for identification.
Provides wiring instructions and connection details for the UDACT with the INA.
To Next Page