•
•
•
•
•
mstdump Added support for the mstdump utility (at beta level) Linux/
Windows
mstmcg Renamed mcg to mstmcg Linux/
Windows
spark spark was removed from mstflint version 3.0.0 Linux/
Windows
Supported
Devices
The following adapter cards and switch systems are no longer
supported in mstflint version 3.0.0:
InfiniHost 4X
InfiniHost III Ex
InfiniHost III Lx 4X
InfiniScale
InfiniScale III
Linux/
Windows
Rev. 2.7.2b
All Added support for WinPE 4.0 OS Windows
Rev. 2.7.2
General It is no longer required to run mst start/stop when using
Winmstflint tools. The service is automatically loaded/unloaded
when an mstflint tool is running. The mst service installation was
removed from the setup
Windows
Added support for SwitchX® silicon devices Windows
mstflint Added support for Atmel AT25DFxx flash family Windows
Added support for burning firmware via Command Line Interface
(CLI) on SwitchX® devices
Windows
mget_temp mget_temp displays a more accurate temperature reading for
ConnectX®-2 and ConnectX®-3 devices by using the adapter’s
specific thermal calibration data
Windows
Rev. 2.7.1a
Added the mcg
tool (Beta level)
The mcg tool displays the current multicast groups and flow
steering rules configured in the device.
Target users: Developers of Flow Steering aware applications. This
tool dumps the internal steering table which is used by the device to
steer Ethernet packets and Multicast IB packets to the correct
destination QPs.
Each line in the table shows a single filter and a list of destination
QPs. Packets that match the filter are steered to the list of
destination QPs
Linux
To Next Page
Loading...
Need help?
General