Release Notes Document History
mstflint Release Notes Change Log History
Component /
Tool
Description Operating
System
Rev. 4.14.0-1
mstresourcedu
mp
Added support for "--virtual-hca-id" command. Now the tool can
provide info on the virtual HCA (host channel adapter, NIC) ID.
For further information see resourcedump Utility
Linux
mstlink HDR lane rate is now supported when in Pseudorandom Binary
Sequence (PRBS) mode.
All
mstreg Increased the registry keys the tool supports and now it exposes the
full PRM. For additional information, refer to the PRM.
All
mstconfig BOOT_INTERRUPT_DIS parameter was added to mlxconfig. When
TRUE, legacy interrupts should not be used for receive/transmit
indication. Polling should be used instead.
Note: This is supported only if
boot_legacy_interrupt_disable_supported is set to TRUE.
All
mstflint Enables the user to to insert information manually to the flash on
components such as MFG/DEV GUID/MAC when no information
exists after the burn process using the command "mstflint -d
<device> sg <guid>". If the information is not inserted manually,
the existing GUID/MAC information will be used instead.
All
mstflint
(Querying the
MFA2 File)
Enables the user to query the MFA2 file using a PSID. For additional
information, refer to Querying the MFA2 File.
All
mstlink Added supported for switching between NRZ/PAM4 speeds for new
devices that support HDR/200G speeds (ConnectX-6, ConnectX-6
Dx, Mellanox Quantum, Mellanox Spectrum 2).
All
Rev. 4.13.3-2
To Next Page
Need help?
General