Nvidia MSTFLINT

28
# mstconfig -d 41:00.0 set BOOT_VLAN_P2=3

Device #1:
----------
Device type: ConnectX3Pro
PCI device: 41:00.0
Configurations: Next Boot New
BOOT_VLAN_P2 1 3

Apply new Configuration? ? (y/n) [n] : y
Applying... Done!
-I- Please reboot machine to load new configurations.
mstconfig Raw Configuration Files
mstconfig allows applying raw configuration file for a pre-set configuration. Raw configurationfiles are
intended for advanced users. This document does not cover the generation of such files.
Set the raw configuration file:
# mstconfig -f ./tlv_file.conf -d 41:00.0 set_raw

Raw TLV #1 Info:
Length: 0xc
Version: 0
OverrideEn: 1
Type: 0x00000080
Data: 0xa0000000 0xa0020010 0x00000000

Raw TLV #2 Info:
Length: 0x4
Version: 0
OverrideEn: 1
Type: 0x01020012
Data: 0x0000000b

Raw TLV #3 Info:
Length: 0x8
Version: 0
OverrideEn: 1
Type: 0x00000190
Data: 0x00000010 0x00007d00

Raw TLV #4 Info:
Length: 0x4
Version: 0
OverrideEn: 1
Type: 0x00000082
Data: 0x0000000c
Operation intended for advanced users.

Are you sure you want to apply raw TLV file? ? (y/n) [n] : y
Applying... Done!
-I- Please reboot machine to load new configurations.
Never apply files from an unreliable source.
