1.
2.
Issue Cause Solution
When Querying for current
configuration on ConnectX-3/
ConnectX-3Pro, some of the
parameters are shown as “N/
A”
The current firmware on
the device does not
support showing the
device's default
configuration
Update to the latest firmware
After resetting configuration
using the tool on 5th
generation (Group II) devices,
the configuration's value
does not change
Firmware loads the default
configuration only upon
reboot
Reboot the server
Installation Related Issues
Issue Cause Solution
Unable to install the tool
package on ESXi platform and
the following message is printed
on the screen:
Got no data from process
Insufficient privileges
Copy the tool's package to /
tmp/vmware and continue
with the installation. If the
issue persists, reboot the
ESX server and try again
Use full file path of the tool's
package
Note: an additional reboot will be
required after completing the
installation
Unable to install kernel-mft in
Linux due to compilation error
that contains the following
message:
'error: conflicting types for
'compat_sigset_t''
CONFIG_COMPAT might not
be enabled in the kernel
configuration.
Set the CONFIG_COMPAT to “y” in
the kernel .config file, and rebuild
the kernel.
To Next Page
Loading...
Need help?
General