•
•
•
•
•
•
•
•
Issue Cause Solution
Burning firmware on a secure device fails
with one of the following messages:
-E- Burning FS3 image failed:
Rejected authentication
The FW image is not secured
The key is not applicable
The image was not secured in a
the proper way.
Ask for a secure
image with the right
keys that match the
device.
Secure Firmware fails when using mstflint
brom and drom commands.
mstflint brom and drom
commands are not supported.
N/A
When the CR space is in read only mode,
the tracers may demonstrate an
unexpected behavior.
A writing permission is required
for them to work properly.
N/A
Applying token on the device fails with one
of the following messages:
Component is not applicable
The manufacturing base MAC was
not listed
Mismatch FW version
Mismatch user timestamp
Rejected forbidden version
The token was not generated or
signed in the proper way.
Generate and sign
tokens.
Burning the firmware using the “--
use_dev_rom” flag has no effect and the
ROM is replaced with the one on the
image.
Controlled firmware does not
support changing boot image
component.
Use “--no_fw_ctrl”.
To Next Page
Loading...
Need help?
General