Oki Data CONFIDENTIAL
42930511TH Rev. 2 273 /
Display on Operating Panel MeasuresMeaning
Black Image Drum Near Life
Black Image Drum Life
Condensing Error
Power Off/On
Power Off/On
nnn:Error
Program Update Mode
Program Data Received OK
Program Data Written OK
Program Data Receive Error
<nnn>
Program Data Receiving
Program Data Write Error <nnn>
Program Data Writing
Belt Unit Near Life
Check Belt Unit
Change Belt Unit
Install New Belt Unit
Belt Unit Life
Belt Unit Life
Error Postscript
No Staple
Could Not Staple. No Staple
Magenta Toner Not Installed
Non Genuine Magenta Toner
Magenta Toner Empty
Magenta Toner Low
A life of the image drum is about
to end.
It is time to change a black
image drum.
Condensation occurs in a printer.
Restart a printer.
Restart a printer due to an
occurance of an error.
The printer is in the program
update mode. (Printing is not
available).
A completion of program data
reception.
A completion of program data
writing.
An error occurs while a recep-
tion of program data.
The printer is receiving the
program data.
An error occurs during a
reception of program data.
Writing a program data is in
process.
A life of a belt unit is about to
end.
A belt unit is installed incorrectly.
Reinstall it.
It is time to change a belt unit
due to a life end of it.
It is time to change a belt unit
due to a life end of it.
It is time to change a belt unit
due to a life end of it.
An error occurs while printing is
in process using a PS driver.
A finisher unit is out of staples.
It is unable to staple because of
no staple.
A magenta toner cartridge is not
installed in a printer or an
unrecognized magenta toner
cartridge is installed.
An unrecognized magenta toner
cartridge is installed.
A magenta toner runs out or a
genuine magenta toner cartridge
is not installed.
The printer runs out of a ma-
genta toner soon.
Prepare a new black image drum
cartridge but unnecessary to change.
Change to a new black image drum
cartridge.
Turn off the power and wait for a while.
Turn off the power again.
Turn off the power again.
–
Wait for a while.
Restart a printer.
Check out a data.
Wait for a while.
Check out a data.
Wait for a while.
Prepare a new belt unit but unneces-
sary to change.
Re-install a belt unit.
Change to a new belt unit.
Change to a new belt unit.
Change to a new belt unit.
Check out a printing data.
Reinstall a staple in a finisher unit.
Set staples. Press the ONLINE button
to clear out a displayed error.
Install a genuine magenta toner
cartridge.
Install a genuine magenta toner
cartridge.
Install a new genuine magenta toner
cartridge.
Prepare a new magenta toner cartridge
but unnecessary to change.
To Next Page
Loading...
Need help?
General
