OKIDATA ML320 - Printer Self-Tests; Selecting Printer Emulation

Getting Started E-11
Selecting an Emulation
Your printer has three emulations:
• Epson
®
FX (ESC/P)
• IBM
®
Proprinter III (PPSII) — factory setting
• OKIDATA
®
MICROLINE
®
Standard
Changing Emulations
1. Make sure paper is loaded.
2. Press
SHIFT + SEL: the printer enters the Menu Mode.
3. Press
LF: the following line prints:
Printer Control Emulation Mode IBM PPR
4. Press TEAR consecutively until the emulation you wish
to select prints in the right-hand column.
5. Press
SHIFT + SEL to save your setting and exit the
Menu Mode.
Running the Self Tests
Font Sample Test ASCII Test
To run the test: To run the test:
Turn the printer Turn the printer
off, then press off, then press
and hold the
LF and hold the
key while
QUIET key while
turning the turning the
printer back on. printer back on.
To stop the test before it To stop the test:
finishes:
Press
SEL. Press SEL.
LF
GROUP
Micro Feed
Down
SEL
SEL
MENU
QUIET
TOF
SEL
SEL
MENU