E-28 Section 3
Language Set. Replaces certain standard symbols with
special characters used in foreign languages.
Line Spacing. Change to 8 lines per inch to get more lines
on a page.
Operator Panel Function. Change to Limited Operation
to deactivate the PRINT QUALITY and CHARACTER
PITCH buttons. This prevents these from being changed
from the control panel when several people are using the
printer.
Page Length. Selects the length of the paper you are
using.
Page Width (Model 321 only). Change to 8" to print on
letter-size paper.
Paper Out Override. Senses when less than 1" (25 mm)
of paper remains and stops printing. Change to Yes to
override the sensor. Caution!! This can cause loss of data
and damage the printhead!
Pin 18. Sets the signal on pin 18 to +5 volts or to open.
Pitch. Choose the character width, in character per inch
(cpi).
Print DEL Code (ML). Change to Yes if you wish to print
the DEL code (decimal 27) as a solid box.
Print Mode. Choose the quality and speed of printing.
Print Registration. Change the setting as required to
obtain the best registration for bi-directional printing.
Print Suppress Effective. If your system uses the DC1
and DC3 codes for something other than the print suppress
mode, change the setting to No.
Proportional Spacing. Change the setting to Yes to engage
proportional spacing of characters.
Receive Buffer Size. Selects the amount of memory
devoted to holding received data. Choosing 1 Line will tie
up your computer while printing, but if you abort the print
job, the printer will stop much sooner.
Reset Inhibit. Select Yes to prevent your software from
resetting your printer's settings.
SI Select Pitch, 10 cpi (IBM). Sets the pitch to be engaged
when the printer control panel is set for 10 cpi and the SI
command is received.
SI Select Pitch, 12 cpi (IBM). Sets the pitch to be engaged
when the printer control panel is set for 12 cpi and the SI
command is received.
Size. Change to Double for double width and height
printing.
To Next Page
Loading...
