FCC/IC/CE
Federal Communications Commission (FCC)
Radio Frequency Interference (RFI) Statement
for 120-Volt Models
WARNING: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
E-47
• Plug the unit into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/television
technician for help.
Note: It is the responsibility of the user to obtain the re-
quired shielded cable in order to ensure compliance of
this equipment with FCC regulations.
Changes or modifications not expressly approved by
OKIDATA may void your authority to operate this device.
Industry Canada (IC)
Radio Interference (RI) Statement
for 120-Volt Models
This OKIDATA apparatus complies with the Class B limits
for radio interference as specified in the Industry Canada
Radio Interference Regulations.
To Next Page
Loading...
