40 Operating modes
After powering on the 3D Ground Navigator metal detector, a splash screen as shown in figure 7.1
appears on screen while the system boots up.
When finished the main menu appears where you have to choose the desired operating mode.
The main menu offers the following operating modes and functions:
• Ground Scan
Conduct a graphical 3d measurement for detailed analysis on a computer.
• Pin Pointer
Transfer live data to Visualizer 3D software to pinpoint potential targets.
• Magnetometer
Process an acoustical magnetic field measurement to detect ferrous metals.
• Transfer to PC
Transfer stored measurements to Visualizer 3D software.
• Settings
Adjust general settings like Bluetooth address, headphones connection etc.
The choice of the operating mode depends on the planned mission. Normally you should use several
operating modes one after another to explore an area. In that way you can obtain as much information
as possible from the underground of the scanned area.
OKM GmbH
www.okmmetaldetectors.com
To Next Page
Loading...
