OKM Future Series - Conducting the Measurement; Figure 7.2: Display Representation in Operating Mode Ground Scan

44 Operating modes
Step 8
The 3D Ground Navigator is trying to connect to your Bluetooth
dongle that must be present at a free USB port on your
computer.
Step 9
After the Bluetooth connection is established, go to the start
position of your first scanning path and start your first scan
line by pushing the start button.
Read section 7.1.2 "Conducting the measurement" on page 44
to learn more about conducting a complete ground scan.
If you are going to finalize this operating mode, simply push
one of the arrow buttons  or .
Step 10
After canceling the Ground Scan screen, the device also exits
the wireless data connection before returning back to the main
menu.
7.1.2 Conducting the measurement
After all parameters has been adjusted the device is ready to start the first scanning path. Beginning
from this moment the display will indicate the current number of scanning paths and the current
number of measured impulses per scanning path.
OKM GmbH
www.okmmetaldetectors.com
Figure 7.2: Display representation in operating mode "Ground Scan"
Number of measure points
which has been recorded
Number of measure points
per scanning path
Number of scanning path
which is currently executed