46 Operating modes
7.2 Pin Pointer
As the name "Pin Pointer" already indicates, it allows you to pinpoint potential targets more precisely.
Furthermore you have the possibility to distinguish between ferromagnetic and non-ferromagnetic
metals.
Normally this operating mode is used after you have executed a complete measurement in operating
mode "Ground Scan". It is mainly used to analyze detected objects in more detail. Due to the analysis of
the measurement results in "Ground Scan" you can determine the position of a located object to know at
which place of the measuring area you should research in detail with the Super Sensor.
7.2.1 Preparing a Pin Pointer scan
In this operating mode all measured data will be sent directly to a computer. Therefor a wireless data
connection to the Visualizer 3D software must be established first.
Step 1
Power on the device and select operating mode "Pin Pointer"
from the main menu. If there is no Super Sensor connected the
button is disabled.
Step 2
If the Super Sensor is connected, please confirm the operating
mode "Pin Pointer" with the OK button.
Step 3
Enter all settings according to your on-going measurement.
Also adjust the Com-Port number according to your local
Bluetooth installation and click the "OK" button of the
Visualizer 3D dialog.
OKM GmbH
www.okmmetaldetectors.com
To Next Page
Loading...
