OKM Future Series - Conducting a Magnetometer Scan; Figure 7.10: Pivoting or Turning the Probe Falisifies the Measurement; Figure 7.9: Probe Should Always Point Downwards and Should Not be Turned

Operating modes 51
Step 4
The display now shows the active Magnetometer screen. You
can repeat the ground balance at any time by pushing the start
button.
If you are going to cancel this operating mode, simply push one
of the arrow buttons  or .
7.3.2 Conducting a Magnetometer scan
Right after activating the “Magnetometer” mode, no sound should come from the device. If you can hear
any sound output, you should repeat the ground balance. Make sure you hold the Super Sensor straight
downwards to the ground, as you would do during the scanning process, and run the ground balance by
pushing the start button. With that the sound output should be silent.
Now you can move slowly forward, backwards and sidewards, but should avoid turning the probe. The
probe should always point vertical to the ground and should not be turned around its own axis.
OKM GmbH
www.okmmetaldetectors.com
Figure 7.9: Probe should always point downwards and should not be turned
Figure 7.10: Pivoting or turning the probe falisifies the measurement
Do not turn around !!!
Do not swing !!!